1-23GETTING STARTED
1
2
3
4
5
6
7
8
9
10
11
GETTING STARTED
12
13
AI
Using the Energy save mode
When the machine has been idle for a predetermined amount of time, the Energy
Save mode will activate to conserve power. By default, the machine will automati
-
cally enter the Energy Save mode after 5 minutes of idle time.
While the Energy Save mode:
• The machine stops the pre-heating for printing and turn off the display.
(However, the scanner lamp will not shut off.)
• [Energy Save] lights in green to indicates that the machine is in the Energy
Save mode.
• Press [Energy Save] to recover from the Energy Save mode.
NOTE:
• The Energy Save mode will not activate in the following cases, even if you
press [Energy Save].
• While scanning documents
• When a document is set in the ADF
* Energy Save mode will not activate when “Calibrating Scanner” appears in
the display.
• When the print error occurs (ex: out-of-paper status, paper jam)
• When the telephone line is used
• When cooling fan is rotating
• For the Energy Save Mode setting, see page 12-12.
• Only the display backlight will be turned out in the following cases.
• When the machine is not used for more than 10 minutes. (The backlight
may not be turned out in some cases, such as while scanning documents.)
• When printing received documents of fax/internet fax, during PC printing,
or when automatically printing lists (ex: check message) in the Energy Save
mode.
To turn on the backlight, press any key on the display or on the control panel.
To Next Page
Loading...
Need help?
General
