VJ-1624/1624W OPERATION MANUAL 4 Handling the printer
4-27
2. Press the [Cutting] key on Operation panel for more than 2 seconds.
• The printer feeds the roll media to the length of the margin and cuts the media.
NOTE
• When loading the new roll media, cut the front edge of the media if it is not straight.
• The cutter is a consumable component.
Replace it periodically.
6.1.4 Replacing Cutter
• When the the media detection is set to "Off", the media cannot be cut automatically.
5.1.4 Media Initial menu
4.4.4 Cutting media manually
This section explains how to cut the roll media manually.
Since VJ-1624 is equipped with Heaters, strictly comply with the following Cautions.
CAUTION
• Right after printing, Media guide becomes very hot.
Allow Media guide to cool down before the next operation.
Follow the procedure below to cut the roll media.
1. Verify the following regarding the operational condition of the printer.
• Printing or other operations are not in progress.
• Operation panel display is Normal.
2. To change the position to cut the roll media, refer to "4.4.1 Feeding media" and advance the roll
media to the desired cut position.
To Next Page
Loading...
Need help?
General