VJ-1624/1624W OPERATION MANUAL 5 Panel setup menu
5-27
5.1.13 Strike Wait menu
Sets up the waiting time while overwrite printing.
NOTE
• When using the media with a narrow width for VJ-1624, Heater cannot warm up the media
adequately, therefore the print quality may not be preserved.
In such a case, set up the Strike Wait time while overwrite printing to warm up the media adequately
before printing.
5.1.14 Slant Check menu
Sets up slanting detection during media loading.
Setup item Setting Description
Strike Wait <0.0 sec.> to 0.1 sec. to 5.0
sec.
Sets the overwrite wait time.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Slant Check Off Slant Check is not performed.
<On> Slant Check is performed.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
To Next Page
Loading...
Need help?
General