MUTOH ValueJet VJ-1624 - Media Initial Menu; Media Width Menu

5 Panel setup menu VJ-1624/1624W OPERATION MANUAL
5-20
5.1.4 Media Initial menu
Sets whether to detect the media width and edge while initializing the media.
NOTE
• When Media Detection menu is set to "Off", set the media width of the current media in Media
Width menu.
5.1.5 Media Width menu
• When the the media detection is set to "Off", the media cannot be cut automatically.
5.1.5 Media Width menu
Specifies the media width between the loading mark and the left end of the media if media detection is
not performed during media initialization.
(1) Media Width menu
Displays the detected media width if media detection is performed during media initialization.
(2) MediaWidth menu
Setup item Setting Description
Init. Off The media will not be detected.
Top&Width Detect the media width and edge while initializing the media.
<Width> Detect the media width while initializing the media.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu