5 Panel setup menu VJ-1624/1624W OPERATION MANUAL
5-22
(2) MediaWidth menu
5.1.6 Output Mode menu
Sets the media ejection method after printing.
NOTE
• When the take-up unit is not installed, do not set Output mode to "Take-up". By doing so, the
product will be unable to function properly.
• When the Output Mode menu is set to "Take-up", the setting for the Prev. Stick menu is disabled.
5.1.9 Prev. Stick menu (VJ-1624 only)
5.1.6.1 Ink Dry Time menu
Set the ink drying time.
Setup item Setting Description
MediaWidth **** mm Display the media width that is detected while initializing.
— • [Cancel] key: shifts to the previous menu.
5.1 Setup menu
Setup item Setting Description
Output mode <Off> Set when not cutting the media automatically after printing.
(Set it to Off even when cutting the media manually.))
Take-up Set when using the take-up unit.
(The media will not be cut after printing.))
Auto cut Set when cutting the media automatically.
5.1.7 Method of Cut menu
— • [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.1 Ink Dry Time menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Ink dry time <0sec> to 60min Set the ink drying time.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.6 Output Mode menu
To Next Page
Loading...
Need help?
General