VJ-1624/1624W OPERATION MANUAL 5 Panel setup menu
5-13
(5) Micro Change menu
Sets up Micro Adjustment Change.
5.1.1.1.4 Pre-heater menu (VJ-1624 only)
Sets the temperature of Pre-heater.
Set to curb a rapid temperature change at the printing portion by pre-heating the media before printing.
NOTE
• This function is not displayed for VJ-1624W.
• The set temperature of Pre-heater differs depending on the media.
Setup item Setting Description
Micro Adj.Change -5.00% to <0.00%> to 5.00% Sets up Micro Adjustment Change.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Pre-heater Off / <30ºC> to 50ºC Sets the temperature of Pre-heater.
1.Roll media
2.Pre-heater
3.Print head
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1 User Type advanced setup menu
23
1
To Next Page
Loading...
Need help?
General