NCR 74 OFX (7874) - Sensormatic Security Tag Deactivation Procedure; Normal Operation

Chapter 4: Operation 4-13
Note: If0.000kg(0.00lb)isnotdisplayed,resetthescalebypressingtheScale
Zerobutton.Ifthisdoesnotwork,turnthescannercircuitbreakerOFFandthen
ON.
2.
PickuptheitemandplaceitinthecenteroftheTopPlate.
Note: Makesuretheitemdoesnotoverhang.Whateverisweighedmustfitfully
ontheTopPlate.
3.
Pressthe“weightrequestkey”(forexample,“4011[PLU]”)ontheterminal.The
weightiscommunicatedtotheterminal.
Thefollowingarepossibleresponsesafterweighinganitem:
•
Ifenabledthroughprogramming,aGoodToneisemittedtoindicatetransmission
ofastable,non–zeroweight.
•
Ifabadweighoccurs,weighthepackageagain(RefertoStep2.)
•
IftheLightBardisplaysanerrorcode,removetheitemfromtheTopPlate.Then
removetheTopPlateandcheckfordebrisunderit.Ifthereisdebris,cleanit.
ReplacetheTopPlate,andthenpresstheScaleZerobuttontoresetthescale.
•
Waitforthe0.000kg(0.00lb)messagetobedisplayed.Whenitisdisplayed,weigh
theitemagain.
Note: IftheLightBarstilldisplaysanerrorcode,contactasupervisor,theService
Company,orNCRCustomerServices.
Sensormatic® Security Tag Deactivation Procedure
Normal Operation
Theoperatingprocedurescanvaryaccordingtotheparametersettings.Thefollowing
procedureassumestheSensormatic®parametersaresettothefollowingvalues.
•
Securitytagdeactivationfunctionisenabled
•
Securitytagdeactivatedtoneisenabled
•
Securitytagdetectedtoneisenabled
FollowingthisprocedureassumestheRealScan74andtheSensormatic®AMB9010
Controllerareturnedonandfunctioningproperly.
1.
Passanitemacrossthescanner.
Note: Asthebarcodegoesthroughthescanzone,theRealScan74readsit.