NCR 74 OFX (7874) - Save the Program; Programming Tags; Abort

Chapter 5: Programming 5-3
Save the Program
1. ScantheSaveandResettag.WhentheSaveandResettagisscanned,thescanner
savesallprogrammingparametersentered.Thisbecomesthenewscanner
program.Thescannergoesthroughinitialstartupandoperatesusingthenew
program.
2.
Saveprogrammingworksheets.Besuretosavetheprogrammingworksheetsthat
containthescannerprogram.Itismucheasiertoreentertheprogram,orchange
someofit,ifawrittenrecordoftheprogramexists.
16402
Normal Operating Mode
Normal Operating Mode
Parameter Program
Programming Mode Tag
Save and Reset Tag
Programming Mode
Parameter Program

Programming Tags
Aftercompletingtheworksheets,entertheinformationusingthespecial
programmingtagscontainedintheNCRScannerProgrammingTags(BST0‐2121‐74)
availableat
www.info.ncr.com.(ThetagsarealsoincludedinAppendixAofthis
document.)Alargenumberofspecialprogrammingtagsarenotneeded.Thereare
onlyfive(5)uniquetagsandsixteen(16)hexadecimal(Hex)charactertags.The
followingidentifieseachprogrammingtag,itsfunction,andtheassociatedindicators.
ABORT
Function–In Base Program Mode
IftheAborttagisscannedintheBaseProgramMode,programmingisterminated
andpreviouslyenteredparametersarenotsaved.