NCR 74 OFX (7874) - UCC-128 Emulation Mode; Bar Codes-6; Codabar Check Digit; Codabar Check Digit Transmission

Chapter 5: Programming 5-37
Scans Required on GS1 DataBar–E
ThisparametersetsthenumberofscansrequiredtoreadaGS1DataBar–Ebarcode.
Increasingthenumberofscanscanimprovereadingnominalbarcodes.Thereare
foursettings:1scan,2scans,3scans,and4scans.Setthisparameterbyscanningthe
appropriateprogrammingtag,Hex1through
Hex4.
UCC–128 Emulation Mode
TheUCC–128EmulationModereferstotheUniformCodeCouncilCod e128Data
FormattedStartCode.Twochoices areavailableforthisparameter.ScantheHex0
programmingtagfornormalmodeortheHex1programmingtagtoenableUCC–128
Emulation.
Bar Codes–6
25515
Codabar
Decoding
A
0
Disable
1
Enable
Codabar
Length
B
0
1-36 1-36
Codabar
Check Digit
C
0
Disable
1
Enable
Your Program
Bar Codes - 6
1 A
A
Codabar
Decoding
B
Codabar
Legth
C
Codabar
Check Digit
Codabar
Check Digit
Transmission
D
0
Disable
1
Enable
D
Codabar
Check Digit
Transmission
Codabar Length Range Check
Maximum Length
(Default = 36)
Minimum Length
(Default = 4)
1
1-36 1-36
Codabar Specific Length Check
Maximum Length
(Default = 36)
Minimum Length
(Default = 4)

TheBarCodes6programmingmodecontainsprogrammingparametersforCodabar
barcodes.Refertothe“ParameterDefaults”sectionearlierinthischapterforthe
factorydefineddefaultvalueofeachprogrammingparameter.