NCR 74 OFX (7874) - Programming Realscan 2357 Hand-Held Scanner if Connected through the USB Peripheral Port

3-44 Chapter 3: Installation
Programming RealScan 2357 Hand-Held Scanner if Connected through the
USB Peripheral Port
Prerequisites:
FirmwareLevels:
• 7874,497‐0461146‐USBHH(pdf417supportnotavailable)
Programming:
Usethefollowingprogrammingsequenceifyouwanttomakethescannerbeep
wheneveritreceivesavalidbarcodedatathroughtheUSBhostport(thescannerdoes
notbeepbydefault):
Selection Programming Tag Sequence
Enable Programming Mode, Hex 4, Hex 0, Hex 5, Save and Reset
Setting
Disable
Required
Programming Mode, Hex 4, Hex 0, Hex 4, Save and Reset
16386D

IftheRealScan2357Hand‐HeldScanner(anymodel)isconnectedtotheRealScan74
throughtheUSBperipheralport,programRealScan2357Hand‐HeldScannerby
scanningthefollowingbarcodesinorder.
ThereisNOprogrammingnecessaryonthe7874forthisconnection.


IfitisdesiredtoscanPDF417(2D)barcodeswiththeHand‐Held,youcanenablethe
RealScan74toallowthepass‐throughofthedatawithouttheRealScan74itself
havingthecapabilitytoreadthattypeofbarcode.
Thefollowingprogrammingsequenceisonly
forUSB‐configuredHand‐Helds:
27023
Selection Programming Tag Sequence
Enable Programming Mode, Hex 7, Hex F, Hex 9, Save and Reset
Disable Programming Mode, Hex 7, Hex F, Hex 8, Save and Reset
Setting
Default
