NCR 74 OFX (7874) - Enable Interleaved 2 of 5 Stitching; Interleaved 2 of 5 Check Digit Length2; Minimum Segment Size; Overlap Characters

Chapter 5: Programming 5-33
Interleaved 2 of 5 Check Digit Length2
Interleaved2of5CheckDigitLength2setsthenumberofdatacharactersdefiningthe
taglength2thatrequiresaCheckDigit.Thistaglengthcouldbeoutsidethenormal
specificlengthorrangeoftaglengthsprogrammingforInterleaved2of5.
Enable Interleaved 2 of 5 Stitching
ThisparameterisonlyvalidiftheInterleaved2of5SpecificLengthisprogrammedas
active.ScanningHexCenablesInterleaved2of5tagstitching.Itisrecommendedthat
stitchingbeenabledonlyifonetagInterleaved2of5lengthisprogrammed.Scanning
HexDdisablesInterleaved2
of5TagStitching.
Scans Required
ThisparametersetsthenumberofscansrequiredtoreadanInterleaved2of5bar
code.Increasingthenumberofscanscanimprovereadingnominalbarcodes.There
arefoursettings:1scan,2scans,3scans,and4scans.Thedefaultis2scans.Setthis
parameterbyscanning
theappropriateHextag(Hex1toHex4).
Overlap Characters
Thisparametersetstheminimumnumberofcharacterswhicheachsegmentmust
containwhentagstitchingisdone.Therearefoursettings:1overlapcharacter(Hex1)
(default),2overlapcharacters(Hex2),3overlapcharacters(Hex3),and4overlap
characters
(Hex4).Setthisparameterbyscanning
theappropriateHextag(Hex1toHex4).
Minimum Segment Size
Thisparametersetstheminimumnumberofcharacterswhicheachsegmentmust
containwhentagstitchingisdone.Setthisparameterbyscanningtheappropriate
Hextag(Hex2toHex9).Thedefaultis
Hex3.