NCR 74 OFX (7874) - Codabar Start;Stop Transmission; Codabar Hard Correlation; Number of Codabar Overlaps Required; Number of Codabar Scans Required

Chapter 5: Programming 5-81
Codabar Start/Stop Transmission
25322

25327
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 1, Hex 2, Save and Resettn*e
TN*e Programming Mode, Hex 6, Hex B, Hex 1, Hex 3, Save and Reset
abcd Programming Mode, Hex 6, Hex B, Hex 1, Hex 0, Save and Reset
ABCD Programming Mode, Hex 6, Hex B, Hex 1, Hex 1, Save and Reset
Setting
Default

Codabar Hard Correlation
25323
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 2, Hex 7, Save and Reset
Disable Programming Mode, Hex 6, Hex B, Hex 2, Hex 6, Save and Reset
Enable
Setting
Default

Number of Codabar Overlaps Required
25580
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex A, Hex 3, Save and Reset3 overlaps
4 overlaps Programming Mode, Hex 6, Hex B, Hex A, Hex 4, Save and Reset
1 overlap Programming Mode, Hex 6, Hex B, Hex A, Hex 1, Save and Reset
2 overlaps Programming Mode, Hex 6, Hex B, Hex A, Hex 2, Save and Reset

Number of Codabar Scans Required
25326
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 6, Hex 3, Save and Reset3 scans
4 scans Programming Mode, Hex 6, Hex B, Hex 6, Hex 4, Save and Reset
1 scan Programming Mode, Hex 6, Hex B, Hex 6, Hex 1, Save and Reset
2 scans Programming Mode, Hex 6, Hex B, Hex 6, Hex 2, Save and Reset
Setting
Default
