NCR 74 OFX (7874) - Power-Up the System

3-32 Chapter 3: Installation
AftersettingtheEASOptionalCommunicationfunctionandtheErrorBarcodetimer,
scanthefollowingResettagtomakethesettingpermanentintheRealScan74.
ResetBarCode

Error, Detect, and Manual Deactivation Bar Codes
ThefollowingaretheError,Detect,andManualDeactivationbarcodes,respectively.
ThesebarcodesareusedfortestingthePOSsystem.Scanthebarcodetosimulatethe
effectonthePOSsystem.
• ErrorBarCode

• DetectBarCode

• ManualDeactivationBarCode

Power-up the System
Note: RefertotheSensormatic®AMB9010Controllerdocumentationforadditional
informationaboutsettingupthecontroller.
Performthefollowingproceduretopower‐upthesystem.
1. TurnontheRealScan74.WhentheRealScan74isfirstturnedon,all
Sensormatic®parametersshouldbeattheirdefaultsettings: