NCR 74 OFX (7874) - Number of Minimum Interleaved 2 of 5 Characters in Interleaved 2 of 5 Partial; Number of Minimum Code 128 Characters in Code 128 Partial; Command-Type Disable; Ignore RS232 Commands from POS

5-84 Chapter 5: Programming
Number of Minimum Interleaved 2 of 5 Characters in Interleaved 2 of 5 Partial
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex E, Hex 4, Save and Reset4 characters
5 characters Programming Mode, Hex 6, Hex B, Hex E, Hex 5, Save and Reset
2 characters Programming Mode, Hex 6, Hex B, Hex E, Hex 2, Save and Reset
3 characters Programming Mode, Hex 6, Hex B, Hex E, Hex 3, Save and Reset
Programming Mode, Hex 6, Hex B, Hex E, Hex 6, Save and Reset6 characters
7 characters Programming Mode, Hex 6, Hex B, Hex E, Hex 7, Save and Reset
24533
Programming Mode, Hex 6, Hex B, Hex E, Hex 8, Save and Reset8 characters
9 characters Programming Mode, Hex 6, Hex B, Hex E, Hex 9, Save and Reset

Number of Minimum Code 128 Characters in Code 128 Partial
Selection Programming Tag Sequence
Setting
Programming Mode, Hex 6, Hex B, Hex F, Hex 4, Save and Reset4 characters
5 characters Programming Mode, Hex 6, Hex B, Hex F, Hex 5, Save and Reset
Programming Mode, Hex 6, Hex B, Hex F, Hex 6, Save and Reset6 characters
7 characters Programming Mode, Hex 6, Hex B, Hex F, Hex 7, Save and Reset
24534
Programming Mode, Hex 6, Hex B, Hex F, Hex 8, Save and Reset8 characters
9 characters Programming Mode, Hex 6, Hex B, Hex F, Hex 9, Save and Reset

Command–type Disable
24959
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex 7, Hex 9, Save and Reset
Disable Programming Mode, Hex 6, Hex 7, Hex 8, Save and Reset
Enable
Setting
Default

Ignore RS232 Commands from POS
24960
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 0, Hex A, Hex 1
Disable Programming Mode, Hex 7, Hex 0, Hex A, Hex 0
Enable
Default
Setting
