NCR 74 OFX (7874) - IBM-485; IBM-USB Tag Data Format; Number System Character Parameter

Chapter 5: Programming 5-53
Thethreeclerkmessagesare:
1.
Scalefailed,cleanunderscaledeck
2.
Scalefailed,code5,cleanunderscaledeck
Next,doscalecalibration
Next,changescale
3.
Scalefailed,code4
Stopcheckstandmechanicalvibration
Next,changescale
IBM–485 / IBM–USB Tag Data Format
ThisoptionisincludedbecausemostIBMdevicesthathaveaselectaddressof4B
requirethebarcodedatatobetransmittedasASCIIcharacters.Therefore,when
selectingCommunicationsProtocolchoice4orB,NCRrecommendsthatthetag
formatbesettoASCII.Forhandheldbarcodereaders,refer
tothe“Communications
Protocol”sectionearlierinthischapter.
Number System Character Parameter
24040
Not Sent
0
Sent
UPC-A & UPC-E
Number System
1
Your Program
Not Sent
4
Sent
UPC-E
Number System
5
1 9
Number System
Character
UPC-A & UPC-E
Number System
Not Sent
6
Sent
UPC-A
Number System
7
UPC-E
Number
System
UPC-A
Number
System

ThisparameterdetermineswhethertheUPC–AandUPC–Enumbersystemcharacter
issentornot.Thefollowingaretheoptionsforthisparameter.
•
Hex0—UPC–AandUPC–ENumberSystemCharacterNotSent
•
Hex1—UPC–AandUPC–ENumberSystemCharacterSent
•
Hex4—UPC–ENumberSystemCharacterNotSent