NCR 74 OFX (7874) - Checkstand Cutout; Realscan 7874-3000;3020 (35.3 CM; 13.9 Inch)

2-4 Chapter 2: Site Preparation
Checkstand Cutout
Whencuttingthecheckstandhole,becarefultomaintainthespecifieddimensions.
Thecheckstandmustbedesignedtodrainlargespillsofliquidsawayfromthebase
ofthescanner.
NCRrecommendsthatanadjustableplatebeplacedbetweentheleadingedgeofthe
RealScan74andthebeltonthe
checkstand.
RealScan 7874-3000/3020 (35.3 cm / 13.9 inch)
35.6 cm
14.0 in
13.0 cm
5.1 in
10.2 cm
4.0 in
29.5 cm
11.6 in
25346
3.2 cm
1.3 in
3.2 cm
1.3 in
3.2 cm
1.3 in
29.5 cm
11.6 in
35.6 cm
14.0 in
Note: Always treat the scanner's profile under the checkstand as a
rectangular prism (a flat-sided box) when measuring the checkstand for a fit.
Do not take advantage of voids or angles in the design of the scanner base
as NCR reserves the right to change the profile without notice as long as the
change does not impact overall outside dimensions.
10.2 cm
4.0 in
