NCR 74 OFX (7874) - Programming the Metrologic Hand-Held Scanner if Connected through the Auxiliary RS232 Port

3-38 Chapter 3: Installation
Programming the Metrologic Hand-Held Scanner if Connected through the
Auxiliary RS232 Port
ScanthefollowingsequenceoftagswiththeMetrologicHand‐HeldScanner.Ifthe
scannerencountersproblemsreadingthesetags,usethetagsprintedinthe
MetrologicInstallationandUser’sGuide:
http://www.metrologic.com/corporate/products/pos/ms9520/
³999999
Enter Config Mode

³999998
Recall Defaults

³415554
Enable RS232

