NCR 74 OFX (7874) - Enable;Disable Voice Messages

5-52 Chapter 5: Programming
IBM Retransmit Control
WhenanIBMterminalisusedandthescaledetectsabadmessagefromtheterminal,
thisparametercontrolshowtheoriginalmessagegetsretransmitted.Ifenableis
selectedbyscanningtheHex7tag,thescaleretransmitstheoriginalmessagethree(3)
times,andthenterminatesthesequence.Ifforever
isselectedbyscanningtheHex8
tag,thescaleretransmitstheoriginalmessageuntilitisaccepted,oruntilthescaleis
toldtoresetbytheterminal.Donotusetheenableselectionunlessadvisedtodoso
byNCRtosolveaproblem.
Enable/Disable Voice Messages
TheRealScan74usesvoicemessagesfordiagnostics,andclerkmessages.Ifvoice
messagesareenabled,themessagesareheardattheappropriatetime;iftheyare
disabled,thebeeptonesareheardinstead.Toenableordisablevoicemessages,scan
thefollowingsequenceofprogrammingtags.Thesetagsmustbe
thefirsttags
scannedafterapplyingpowertotheunit.
All Voice Messages Off/On
•
ProgramMode
•
Hex3
•
Hex2
•
HexD
•
SaveandReset
Clerk Messages On
•
ProgramMode
•
Hex3
•
Hex3
•
Hex1
•
SaveandReset
Clerk Messages Off
•
ProgramMode
•
Hex3
•
Hex3
•
Hex0
•
SaveandReset
BecausetheclerkmessagesareasubsetoftheVoiceMessages,disablingallvoice
messagesdisablestheclerkmessagesalso.AllVoiceMessagesmustbeenabledfor
theClerkMessagestobeenabled.