NCR 74 OFX (7874) - Page 221

Chapter 5: Programming 5-113
Note: IftheUpdatescannerwith:groupboxisenableduponselectingtheExtract
fromscannerto:checkbox,thefollowingerrormessagedisplays.

8.
SelectthePrepFlashDrivebutton.Theapplicationthenprepstheflashdrive.The
followingmessageboxdisplaysafterasuccessfulflashdriveprep.

TheUparrowofthe2ndlineintheScannerConfigurationPreviewPanelunder
7874highlights.

9.
Right‐clicktheSafelyRemoveHardwareicononthesystemtraytosafelyremove
theflashdrive.ASafetoRemoveHardwareballoonmessagedisplaysnearthe
systemtray.
10.
PlugtheFlashDriveinthescannerʹsUSBperipheralport.
Thescannergivesoffatriplebeepofascendingfrequency,whichindicatesthat
theUSBperipheralportrecognizedtheFlashDriveandwasabletoenumerate.
ThetriplebeepsoundsoffregardlessofthecontentsoftheFlashDrive.If
the
scannerfailstogiveoffthetriplebeep,thisindicatesaUSBperipheralportfailure
ortheUSBperipheralportwasnotabletocommunicatewiththeFlashDrive.
ThescannerthenspeaksʺLoadprogramin3seconds...2...1...0...ʺthenthescanner
resets.