Replacing Parts
Low-Speed Encoder
NCR iTRAN 180es/300es/600 Operator’s Guide 4-33
5 Now you want to get the broken end of the unused ribbon to the point
that it is lying in the cabinet bottom, ready to re-attach to the take-up roll.
• If the ribbon is already accessible in the cabinetry bottom (if it has
broken just before reaching the take-up spool), make sure the ribbon
is torn all the way across. Then go to step 6.
• If the ribbon is not accessible in the cabinetry bottom (if it has
broken before passing over the print-head, or somewhere inside the
mechanism) perform the following steps.
• Wind the ribbon back onto the feed spool.
• Pull the end of the ribbon toward you until it is completely clear of
the encoder compartment.
To Next Page
Loading...