Confidential and proprietary information of NCRCorporation.
Unauthorized use, reproduction and/or distribution is strictly prohibited.
86
Operator Controls
Power Switch
The Power Switch is located on the bottom of the display. This switch is a momentary
contact, push-on-push-off switch.
The behavior of the Power Switch is controlled by an Operating System setting. Options
typically include:
l
Do nothing
l
Sleep
l
Hibernate
l
Shut down
l
Turn off the Display
Do nothing is the recommended setting to avoid accidental power cycles. To ensure a
stable system, power cycles should only be controlled through the customer POS
application.
Warning
If the Power Switch is pressed for four seconds when powering down, the
hardware level override of the processor forces an uncontrolled shutdown. This
can corrupt the Operating System. The ONESHOT feature disables this hardware
override. To turn on the ONESHOTfeature, refer to the following procedures:
Enabling ONESHOT on page199.