NCR VOYIX CX7 - Connecting AC Power

Confidential and proprietary information of NCRCorporation.
Unauthorized use, reproduction and/or distribution is strictly prohibited.
98
Connecting ACPower
Caution
Do not connect or disconnect the Power Cable from the terminal with the
AC Power Cord connected to an AC outlet. It is recommended to disconnect
the AC Power Cord from the AC outlet and wait 30 seconds before connecting or
disconnecting the Power Supply cable from the terminal.
The CX7 receives power from an external 24V power brick.
Caution
The CX7 requires the NCR 24V power supply that is shipped with the terminal.
Use of other power bricks may cause damage to the unit.
1. Connect the Power Supply cable to the Power In connector on the Base.
2. Connect the AC Power Cord to the Power Supply and to an AC outlet.