EasyManua.ls Logo

NEC Aspire S IntraMail - Page 126

NEC Aspire S IntraMail
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Make Call
116 Chapter 2: Features IntraMail for Aspire System Guide
3.2 14-06-01: Trunk Group Routing
- Set up Trunk Group Routing. There are 8 routing tables, with 4 routes in each table.
By default, the rst route in routing table 1 is trunk group 1. No other entries are dened.
This makes trunk group 1 the dial 9 route by default.
3.3 Refer to Trunk Group Routing in the Aspire Software Manual (P/N 0893200) for more.
Step 4 Enable Loop Supervision for the trunks on which you are going to allow remote logons to
use Make Call.
4.1 14-01-13: Basic Trunk Data Setup - Loop Supervision
- Enter 1 to enable Loop Supervision for each trunk to be used for External Transfer.
By default, this option is enabled for all trunks.
Step 5 If you are going to allow remote logos to use Make Call, enable Trunk-to-Trunk Transfer for all
IntraMail extensions.
5.1 20-11-14: Class of Service Options (Hold/Transfer Service) - Trunk-to-Trunk Transfer
- For each IntraMail extension to be used for External Transfer (343-350), enter 0 to enable
Trunk-to-Trunk Transfer. (Entering 1 disables Trunk-to-Trunk Transfer).
By default, Trunk-to-Trunk Transfer is enabled (0) for all IntraMail extensions (343-350).
5.2 20-06-01: Class of Service for Extensions
- Assign Class of Service to extensions (1-15).
By default, IntraMail extensions (343-350) have Class of Service 1.
Operation
Using Make Call from your Mailbox
[Super Display Soft Key] - [Keyset Soft Key]
Log onto Subscriber Mailbox.
L (5) Listen to the message for which you want to make a return call.
[Listen] - [Lstn]
MC (62) Dial this code while listening to the message you want to return.
[Callback] - [N/A]
Make Call automatically places a return call to the co-worker that left you the message.
If your system has Caller ID, Make Call can automatically place a return call to your
outside caller.
If you hear “Your call cannot go through,” your system’s Caller ID is not properly set
up. You go right back to the listen mode for the message you were listening to when
you tried the Make Call.

Table of Contents

Related product manuals