NEC Aspire S IntraMail - Checking the CPU LEDs and Powering Down

Installation
Installing the IntraMail PCB
IntraMail for Aspire System Guide Chapter 1: Quick Setup ◆ 3
1
Checking the CPU LEDs and Powering Down
Before powering down, you must check the CPU PCB LEDs.
Step 1 Carefully check the CPU LEDs (Figure 3: Checking the CPU LEDs) .
- Make sure that LD2 is the only LED flashing on the CPU.
(
LD2 flashes green 1/2 second on and 1/2 second off.)
- If any other LEDs on the CPU are flashing, wait until they stop.
-
If you turn off the system while LEDs other than LD2 are flashing, system data could become
corrupted as the system powers down.
Figure 3: Checking the CPU LEDs
Step 2 Turn the power switch to OFF.
08931
0
0-163
LD2
LD4
LD3
LD1