Start-Up Programming
Default Programming
IntraMail for Aspire System Guide Chapter 3: Programming ◆ 189
3
8.4 15-03-06: Single Line Telephone Basic Data Setup, Extension Reverse
- Disabled (0) for extensions 343-350.
8.5 15-03-09: Single Line Telephone Basic Data Setup, Caller ID Function for External Module
- Disabled (0) for extensions 343-350.
8.6 45-02-01: NSL Option Setup, Send DTMF Tone or 6KD Message
- The 6KD Message is enabled (1).
- With 6KD enabled, the system uses NSL messages to communicate with an IntraMail
voice mail port (rather than DTMF tones). This is required for IntraMail operation.
8.7 45-02-03, NSL Option Setup, Send 5IA Message
- The 51A Message is enabled (1).
- With 5IA enabled, when an IntraMail port is placing a call the system will send NSL mes-
sages to IntraMail that provide the call status. This typically occurs during Make Call and
Message Notification callouts. This is required for IntraMail operation.
Optional IntraMail Start Up Programming
Step 1 Program Voice Mail keys on system extensions.
1.1 15-07-01: Programming Function Keys
- Voice Mail keys are code 77.
- Normally, the additional data is the number of the extension you are programming.
- You can optionally set up an extension’s MSG key for Voice Mail access in the next step.
- Keysets can also have Voice Mail keys for Virtual Extensions, a co-worker, or an unin-
stalled extension (for Message Center operation).
- Extension users can use Service Code 851 to set up their own Voice Mail keys.
✔ By default, there are no Voice Mail keys assigned.
To Next Page
Loading...