NEC Aspire S IntraMail - 47-01-03: Subscriber Message Length; 47-01-04: Non-Subscriber Message Length

Program 47: IntraMail
47-01: IntraMail System Options
194 ◆ Chapter 3: Programming IntraMail for Aspire System Guide
Keys for Entering Names
47-01-03: Subscriber Message Length
(Subs Msg Length)
Use this option to set the maximum length of recorded messages for:
■ Subscriber Mailbox users dialing RS to record and send a message.
■ Extension users leaving a message in a Subscriber Mailbox.
■ Outside Automated Attendant callers accessing a mailbox via a GOTO command and then dialing RS
to record and send a message.
■ Subscriber Mailbox Greetings.
■ Announcement Messages.
■ Call Routing Mailbox Instruction Menus.
Note: The length of a Conversation Record is 10 times the Subscriber Message Length. Since the Conversa-
tion Record time cannot exceed 4095 seconds, any settings in Subscriber Message Length larger than 409
has no effect on the length of recorded conversations.
See the following for more:
■ Announcement Message on page 33.
■ Automated Attendant on page 47.
■ Call Routing Mailbox on page 54.
■ Conversation Record on page 60.
■ Greeting on page 89.
■ Subscriber Mailbox on page 162
Options
■ 1-4095 seconds.
Default
✔ 120 seconds.
47-01-04: Non-Subscriber Message Length
(Mbox Msg Length)
Use this option to set the maximum length of recorded messages for:
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→→
→→
←←
←←
Á À Â Ã Ç É Ê ì ó
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, d-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
* Enter characters:
* + , - . / : ; < = > ? π ∑
σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space (user programming) or
CONF Clear the character entry one character at a time.
CLEAR Clear all the entries from the point of the flashing cursor and to the
right.
the → soft key in system programming.