NEC Aspire S IntraMail - Powering up and Checking the Leds

Installation
Installing the IntraMail PCB
IntraMail for Aspire System Guide Chapter 1: Quick Setup ◆ 7
1
Powering Up and Checking the LEDs
Step 1 Power up the system.
- Remove the grounded wrist strap.
- Turn the cabinet power switch to
On.
Step 2 Check the CPU LEDs (Figure 7: Checking the CPU LEDs).
- Wait about 10 seconds, then verify the CPU LEDs.
- Make sure that
LD2 is the only LED flashing on the CPU.
(LD2 flashes green 1/2 second on and 1/2 second off.)
Figure 7: Checking the CPU LEDs
08931
0
0-164
LD2
LD4
LD3
LD1