DS1000/2000 Correspondence Course
System Programming
NEC America DS1000/2000 Workbook ◆ 131
Using Keys to Move Around in the Programs
Once you enter the programming mode, use the keys in the following chart to
enter data, edit data and move around in the menus.
Use this key: When you want to:
0-9, # and * Enter data into the program.
HOLD Complete the programming step you just made (like press-
ing Enter on a PC keyboard). When a program entry dis-
plays, press HOLD to accept the entry (i.e., bypass the
entry without changing it).
CONF Complete the programming step you just made (like pressing
Enter on a PC keyboard) and back up one step in the program.
LND Delete the entry to the left (like pressing Backspace on a
PC keyboard).
To delete an entire name entry (without backspacing over
each letter), just reenter the name without pressing LND first.
CLEAR Erase the entire command line you just entered and unde-
fine the entry.
CHECK Erase the entry you just made and replace it with the prior
stored entry.
VOL ▲ Scroll forward through a list of entries in a program. If you
enter data and then press this key, the system accepts the
data before scrolling forward to the next entry.
VOL ▼ Scroll backward through a list of entries in a program. If
you enter data and then press this key, the system accepts
the data before scrolling backward to the previous entry.
ICM Enable the scroll mode. When you press this key and it lights,
you can then press VOL ▲ and VOL ▼ to scroll through the
options. To choose the displayed value, press HOLD.
To Next Page
Loading...
Need help?
General
