NEC DS1000 Correspondence Course Workbook

DS1000/2000 Correspondence Course
System Programming
NEC America DS1000/2000 Workbook ◆ 143
Program 1804 - Extension Trunk Group Access
Use this program to assign the outgoing access to trunk groups.
Incoming trunk group access is always allowed.
1. Enter the programming mode.
2. 1804 +
HOLD
3. Enter the extension number you want to program + HOLD
OR
Press
HOLD to select extension 300.
The previously programmed value displays.
4. Enter the number of the trunk group (0-8) you want to program +
HOLD
OR
Press
HOLD to select trunk group 1.
The previously programmed value displays on the second line. The
first line of the display shows the extension and trunk group you are
programming.
5. Enter Y to allow or N to prevent outgoing access to the trunk group selected +
VOL ▲
OR
Press
VOL ▲ to leave the current unchanged.
You see the options for the next consecutive trunk group. The previ-
ously programmed value displays.
6. Enter Y to allow or N to prevent outgoing access to the trunk group selected +
VOL ▲
OR
Press
CONF to select another trunk group.
OR
Press
CONF twice to select another extension.
OR
Press
CONF three times to exit the program.
1804:LINE GRP ACCESS
STATION #?nnn
1804: STA nnn
LINE GROUP?n
1804:STA:nnn GRP:n
LINE GROUP n:nnn
1804:STA:nnn GRP:n
LINE GROUP n:nnn

NEC DS1000 Specifications

General

Brand	NEC
Model	DS1000
Category	Telephone
Language	English