NEC DS1000 - Page 160

DS1000/2000 Correspondence Course
System Programming
160 ◆ DS1000/2000 Workbook NEC America
Step 5: Should trunk overflow during the night mode?
• In Program 1003 - Activate Overflow at Night
enter Y.
• In Program 1003 - Night Overflow Destination
assign the extension, Ring Group, UCD Group
master number or Voice Mail master number you
want to use for the trunk’s night mode overflow
destination.
• In Program 1003 - Activate Overflow at Night
enter N.
Step 6: Do the trunks ring their initial mode destinations for the correct interval before
diverting to the overflow destination?
• In Program 0401 - Trunk Revert leave the Trunk
Revert interval at is currently assigned value.
• In Program 0401 - Trunk Revert change the Trunk
Revert interval to meet the site requirements.
Step 7: Do the trunks ring their overflow destinations for the correct interval before divert-
ing to the Key Ring?
• In Program 0401 - Transfer Recall leave the
Transfer Recall interval at is currently assigned
value.
• In Program 0401 - Trunk Revert change the
Transfer Recall interval to meet the site require-
ments.
Step-by-step guide for setting up Key Ring
(Sheet 2 of 2)
If yes
If no
If yes
If no
If yes
If no