NEC Express5800 Series User Manual

4-78 System Configuration
As shown below, the window showing writing process appears for each update target.


If any error is detected during the writing process, an error message is displayed and the process
terminates.


End of writing
When writing is completed, the “Status” column displays the result for each target.

CHECK:
OK
OK
 To apply updates for targets other than applet, reboot the server or power off and then on
the server.
 When you rebooted or power on the server to apply an update for BMC software, SDR, or
PIA, the connection with BMC will be disconnected. Because of this, you need to log in
again.
 To apply updates for applets, log out once, close all browsers, and then logon again. You do
not need to reboot the server.


NEC Express5800 Series Specifications

General

Series	Express5800
Category	Server
Processor	Intel Xeon processors
Network	Gigabit Ethernet, 10 Gigabit Ethernet (Varies by model)
Operating System Support	Windows Server, Linux variants
Form Factor	Tower, Rackmount (1U, 2U, etc. - varies by model)
Memory	DDR4 ECC DIMM (Capacity varies by model)
Storage	SAS/SATA HDD/SSD, NVMe SSD (Configuration varies by model)