5-56 Installing and Using Utilities
Procedure in the Server Maintenance Utility
Perform the procedure below before replacement of a module.
1. Select the target module from the main window of the Server Maintenance Utility.
The screen of the target module appears.
2. Check the current state of the target module with the LEDs.
3. Select [Clear] in [MTBF Clear] of the target module.
You can confirm the MTBF clear result by checking the LEDs of the target component. The
result is registered in the syslog.
4. Start the component.
Sample screen of Server Maintenance Utility
[PCI Module] screen
Main window
To Next Page
Loading...
