UX5000 IP Data Maintenance
UX5000 IP Resource Manual 6 - 47
6.6 Appendix: Error Messages
Setting-Related
Connection-Related
Message There is invalid parameter.
Explanation Some items are not yet entered on the Upload or Download
screen.
Response Check if the following items are correctly entered:
Extension number or IP address selected in “Specified
Terminal”
ID set in “User authentication”
Password set in “User authentication”
Message There is invalid network setting.
Explanation The terminal with the IP address specified in “Specified Terminal”
and the PC with the IP address specified in “Network setting of
this computer” cannot communicate with the network.
Response Check if the terminal with the IP address specified in “Specified
Terminal” and the PC with the IP address specified in “Network
setting of this computer” can communicate with the network.
Message Can not find specified telephone. Connection will be closed.
Explanation The terminal (telephone) with the specified extension number
was not found.
Response Check the following:
Does the terminal with the extension number specified in
“Specified Terminal” really exist?
Are you logging into the terminal in WebPro? If so, log out.
If the Menu screen is displayed, close it.
Is the application of the terminal (local IPM port) set to 3530?
Message There is duplicate telephone. Connection will be closed.
Explanation Several terminals with the specified extension number were
found.
Response Contact your system administrator.
Message There is authentication error. Connection will be closed.
Explanation An attempt to log into the terminal failed.
Response Check if the ID or password specified in “User authentication” on
the Download or Upload screen is correct.
Message There is connection error. Connection will be closed.
Explanation There is no response from the terminal.
Response Check the following:
Is this terminal a model supported by the Maintenance Tool?
Is the IP address specified in “Specified Terminal” correct?
(there is no terminal with the specified IP address.)
Is the application of the terminal (local IPM port) set to 3530?
Is the security setting (WebPro) of the terminal enabled?
To Next Page
Loading...
