NEC UX5000 - Figure 2-10 163 Protocol Settings; Figure 2-11 Scope Options

UX5000 IP Terminal AutoConfig Setup
UX5000 IP Resource Manual 2 - 7
◆ 163 Protocol – This is the transmission that will be used (FTP).
Select Add to enter the third NEC option code. Enter an option code
name (Protocol) in the Name field. Set the Data Type field to Byte, and
enter 163 in the Code field. Select OK to save the settings.
10. Left-click Scope options and select Configure Options to configure each
defined NEC option codes.
Figure 2-10 163 Protocol Settings
Figure 2-11 Scope Options