NEC UX5000 - Dhcp Setup and Configuration; Figure 2-2 Selecting Server

UX5000 IP Terminal AutoConfig Setup
2 - 2 IP Terminal AutoConfi
g
Setu
p
1. Use the Auto Configuration application to create a terminal configuration
file with corresponding network and telephony data parameters that are
needed to connect the UX5000 IP terminal to the UX5000. This created
Auto Configuration file needs to be loaded onto a network accessible PC/
Server with a FTP server running.
2. Plug the UX5000 IP terminal into the local network (Factory Value
Settings).
3. A local DHCP server will provide Vendor Specific Options for the UX5000
IP terminal.
4. The UX5000 IP terminal will use the DHCP Vendor Specific Options to
communicate with the local FTP Server.
5. The UX5000 IP terminal will download the created AutoConfig file from the
FTP Server.
6. The UX5000 IP terminal will initialize with its new downloaded
configuration settings and connect to the UX5000.
SECTION 2 DHCP SETUP AND CONFIGURATION
1. Left-click on the Server to be used.
Figure 2-2 Selecting Server