NEC UX5000 - Figure 2-33 Build Configuration File - Assign 1 St Server Port

UX5000 IP Terminal AutoConfig Setup
UX5000 IP Resource Manual 2 - 29
1. Click on the 1st Server Address to bring up the window shown on the right
side of screen.
2. Assign the IP address.
❍ Clicking the Input Type Change button changes the entry from IP to URI.
3. Click OK to finish.
1. Click on the 1st Server Port to bring up the window shown on the right side
of screen.
2. Assign the Port number.
3. Click OK to finish.
Figure 2-33 Build Configuration File – Assign 1st Server Port
1
2
3