NEC UX5000 - Figure 1-16 Command Drop-Down List

UX5000 IP Phone Manager
UX5000 IP Resource Manual 1 - 19
5.2 Reset
The Reset function will reset the terminal(s) to which the IP Phone Manager is
connected. There are two options for resetting the connected terminal(s):


Soft Reset – Application layer of the terminal


Hard Reset – Full hardware initialization of the terminal
Click on the check box for the terminal(s), select the Reset option from the
Command drop-down list, and click the Execute button.
Select to perform a Soft Reset or Hard Reset from the radio button options.
Select the Command Transmit to use (Send Once, Immediately or Send
Until Successful - see page 1-14) and click Execute.
The status changes from “OK” to “Soft ResetOK” or “Hard ResetOK”.
Figure 1-16 Command Drop-Down List