NEC UX5000 - IP Terminal Autoconfig Setup; Introduction; Figure 2-1 Network Operation and Topology

UX5000 IP Resource Manual 2 - 1
IP Terminal AutoConfig Setup
2IP Terminal AutoConfig Setup
SECTION 1 INTRODUCTION
This chapter describes the operation of the Auto Configuration File
application for UX5000 IP Value, Enhanced or IP-CTS terminals. To
access these screens, click the Auto Config button from the IP Phone
Manager main screen.
Figure 2-1 Network Operation and Topology and the steps that follow
describe the process that the IP terminal uses to automatically configure
itself using common network devices (Plug and Play).
Figure 2-1 Network Operation and Topology