NETGEAR GS752TP - Page 120

Configuring Switching Information
120
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Configuration changes take place immediately.
Multicast Group Membership
The multicast Group Membership screen displays the ports and LAGs attached to the
selected VLAN and the multicast service group. The Port and LAG tables also reflect the
manner in which the port or LAGs joined the multicast group.
 To configure the Multicast group membership:
1. Select Switching
 Multicast  Static Multicast Address  Multicast Group
Membership.
The following screen displays:
2. Select the VLAN for which you want to configure multicast group settings.
• To configure the multicast group for a physical port, click PORTS.
• To configure
the multicast group for a link aggregation group (LAG), click LAGS.
• To configure the multicast group for both physical ports and LAGs, click All
.
3. Select the check box next to the interfaces to configure.
Y
ou can select multiple interfaces to apply the same setting to the selected interfaces.
Select the check box in the heading row to apply the same settings to all interfaces.
4. Select the status of the interfaces.
The possible values are:
• Static. Attaches the interface to the multicast group as a static member
.