NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Firewall Protection 4-33
v1.0, April 2010
2. In the Add Customer Service section of the screen, enter the settings as explained in Table 4-6.
3. Click Apply to save your settings. The new custom service is added to the Custom Services
Table.
To edit a service:
1. In the Custom Services table, click the Edit table button to the right of the service that you
want to edit. The Edit Service screen displays.
2. Modify the settings that you wish to change (see Table 4-6 on page 4-33).
Table 4-6. Services Settings
Setting Description (or Subfield and Description)
Name A descriptive name of the service for identification and management purposes.
Type From the Type drop-down list, select the Layer 3 protocol that the service uses as its
transport protocol:
•TCP.
• UDP.
• ICMP.
ICMP Type A numeric value that can range between 0 and 40. For a list of ICMP types, see
http://www.iana.org/assignments/icmp-parameters.
This field is enabled only when you select ICMP from the Type drop-down list.
Start Port The first TCP or UDP port of a range that the service uses.
This field is enabled only when you select TCP or UDP from the Type drop-down list.
Finish Port The first TCP or UDP port of a range that the service uses. If the service uses only a
single port number, enter the same number in the Start Port and Finish Port fields.
This field is enabled only when you select TCP or UDP from the Type drop-down list.
Figure 4-20