ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
1-10 Introduction
v1.0, April 201010
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
For information about accessing the command line interface (CLI) using the console port, see
“Using the Command-Line Interface” on page 8-14.
3. Factory default reset button. Using a sharp object, press and hold this button for about eight
seconds until the front panel Test light flashes to reset the SRX5308 to factory default settings.
All configuration settings are lost, and the default password is restored.
4. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).
5. A power on/off switch.
Bottom Panel with Product Label
The product label on the bottom of the SRX5308’s enclosure displays factory default settings,
regulatory compliance, and other information.
Figure 1-3
To Next Page
Loading...
