NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
System Logs and Error Messages C-5
v1.0, April 2010
Multicast/Broadcast Logs
WAN Status
This section describes the logs generated by the WAN component. If there are several ISP links for
Internet connectivity, the VPN firewall can be configured either in auto-rollover or load balancing
mode.
Load Balancing
When the WAN mode is configured for load balancing, all the WAN ports are active
simultaneously and the traffic is balanced between them. If one WAN link goes down, all the
traffic is diverted to the other WAN links that are active.
This section describes the logs generated when the WAN mode is set to load balancing.
Recommended Action To enable these logs, from the CLI command prompt of the router, enter this
command:
monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 1
And to disable it enter:
monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 0
Table C-10. System Logs: Multicast/Broadcast
Message Jan 1 07:24:13 [SRX5308] [kernel] MCAST-BCAST IN=WAN OUT=SELF
SRC=192.168.1.73 DST=192.168.1.255 PROTO=UDP SPT=138 DPT=138
Explanation • This packet (Broadcast) is sent to the device from the WAN network.
• For other settings, see Table C-1.
Recommended Action None
Table C-11. System Logs: WAN Status, Load Balancing
Message Dec 1 12:11:27 [SRX5308] [wand] [LBFO] Restarting WAN1_
Dec 1 12:11:31 [SRX5308] [wand] [LBFO] Restarting WAN2_
Dec 1 12:11:35 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(UP)_
Dec 1 12:24:12 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_
Dec 1 12:29:43 [SRX5308] [wand] [LBFO] Restarting WAN2_
Dec 1 12:29:47 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_
Table C-9. System Logs: Unicast, Redirect (continued)