ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Virtual Private Networking Using IPsec Connections 5-3
v1.0, April 2010
Using the IPsec VPN Wizard for Client and Gateway
Configurations
You can use the IPsec VPN Wizard to configure multiple gateway or client VPN tunnel policies.
The following section provides wizard and NETGEAR
ProSafe VPN Client software
configuration procedures for the following scenarios:
• Using the wizard to configure a VPN tunnel between two VPN gateways.
• Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client.
Configuring a VPN tunnel connection requires that all settings on both sides of the VPN tunnel
match or mirror each other precisely, which can be a daunting task. The VPN Wizard efficiently
guides you through the setup procedure with a series of questions that determine the IPsec keys
and VPN policies it sets up. The VPN Wizard also configures the settings for the network
connection: security association (SA), traffic selectors, authentication algorithm, and encryption.
The settings that are used by the VPN Wizard are based on the recommendations of the VPN
Consortium (VPNC), an organization that promotes multivendor VPN interoperability.
Creating Gateway-to-Gateway VPN Tunnels with the Wizard
To set up a gateway-to-gateway VPN tunnel using the VPN Wizard.
1. Select VPN > IPSec VPN from the menu. The IPsec VPN submenu tabs display, with the IKE
Policies screen in view (see Figure 5-20 on page 5-22).
2. Click the VPN Wizard submenu tab. The VPN Wizard screen displays (see Figure 5-4 on
page 5-4, which contains some entries as an example).
Figure 5-3
To Next Page
Loading...
