NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
2-34 Connecting the VPN Firewall to the Internet
v1.0, April 2010
5. Click Apply to save your changes.
If you want to configure the advanced settings for an additional WAN interface, select another
WAN interface and repeat these steps.
Additional WAN-Related Configuration Tasks
• If you want the ability to manage the VPN firewall remotely, enable remote management (see
“Configuring Remote Management Access” on page 8-10). If you enable remote management,
NETGEAR strongly recommend that you change your password (see “Changing Passwords
and Administrator Settings” on page 8-8).
• You can set up the traffic meter for each WAN, if desired. See “Enabling the WAN Traffic
Meter” on page 9-1.
Upload/Download Settings
These settings rate-limit the traffic that is being forwarded by the VPN firewall.
WAN Connection Type From the drop-down list, select the type of connection that the VPN firewall
uses to connect to the Internet: DSL, ADLS, Cable Modem, T1, T3, or
Other.
WAN Connection Speed
Upload
From the drop-down list, select the maximum upload speed that is
provided by your ISP. You can select from 56 Kbps to 1 Gbps, or you can
select Custom and enter the speed in Kbps in the field below.
WAN Connection Speed
Download
From the drop-down list, select the maximum download speed that is
provided by your ISP. You can select from 56 Kbps to 1 Gbps, or you can
select Custom and enter the speed in Kbps in the field below.
Warning: Depending on the changes that you made, when you click Apply, the
VPN firewall might restart, or services such as HTTP and SMTP might
restart.
Table 2-8. Advanced WAN Settings (continued)
Setting Description (or Subfield and Description)