NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
4-50 Firewall Protection
v1.0, April 2010
2. Below Add Port Triggering Rule, enter the settings as explained in Table 4-11.
3. Click the Add table button. The new port triggering rule is added to the Port Triggering Rules
table.
Figure 4-29
Table 4-11. Port Triggering Settings
Setting Description (or Subfield and Description)
Name A descriptive name of the rule for identification and management purposes.
Enable From the drop-down list, select Yes to enable the rule. (You can define a rule but
not enable it.) The default setting is No.
Protocol From the drop-down list, select the protocol to which the rule applies:
• TCP. The rule applies to an application that uses the Transmission Control
Protocol (TCP).
• UDP. The rule applies to an application that uses the User Control Protocol
(UCP).
Outgoing (Trigger)
Port Range
Start Port The start port (1–65534) of the range for triggering.
End Port The end port (1–65534) of the range for triggering.
Incoming (Response)
Port Range
Start Port The start port (1–65534) of the range for responding.
End Port The end port (1–65534) of the range for responding.