ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
4-52 Firewall Protection
v1.0, April 2010
2. To enable the UPnP feature, select the Yes radio button. (The feature is disabled by default.)
To disable the feature, select No.
3. Configure the following fields:
– Advertisement Period. Enter the period in minutes that specifies how often the VPN
firewall should broadcast its UPnP information to all devices within its range. The default
setting is 40 minutes.
– Advertisement Time to Live. Enter a number that specifies how many steps (hops) each
UPnP packet is allowed to propagate before being discarded. Small values will limit the
UPnP broadcast range. The default setting is 4 hops.
4. Click Apply to save your settings.
To refresh the contents of the UPnP Portmap Table, click Refresh.
Figure 4-31
To Next Page
Loading...
