NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall - Page 241

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Managing Users, Authentication, and Certificates 7-13
v1.0, April 2010
4. In the Defined Addresses Status section of the screen, select one of the following radio
buttons:
• Deny Login from Defined Addresses. Deny logging in from the IP addresses in the
Defined Addresses table.
• Allow Login only from Defined Addresses. Allow logging in from the IP addresses in
the Defined Addresses table.
5. Click Apply to save your settings.
6. In the Add Defined Addresses section of the screen, add an address to the Defined Addresses
table by entering the settings as explained in Table 7-5.
Figure 7-8
Table 7-5. Add Defined Addresses Settings
Setting Description (or Subfield and Description)
Source Address Type Select the type of address from the drop-down list:
• IP Address. A single IP address.
• IP Network. A subnet of IP addresses. You must enter a netmask length in
the Mask Length field.
Network Address / IP
Address
Depending on your selection of the Source Address Type drop-down list,
enter the IP address or the network address.
Mask Length For a network address, enter the netmask length (0–32).
Note: By default, a single IP address is assigned a netmask length of 32.