ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Troubleshooting and Using Online Support 10-9
v1.0, April 2010
The VPN firewall reboots. During the reboot process, the Settings Backup & Firmware Upgrade
screen might remain visible. The reboot process is complete after several minutes when the Test
LED on the front panel goes off.
Figure 10-1
Warning: When you push the hardware reset button or click the software Default
button, the VPN firewall settings are erased. All firewall rules, VPN policies,
LAN/WAN settings, and other settings are lost. Back up your settings if you
intend on using them.
Note: After rebooting with factory default settings, the VPN firewall’s password is
password, and the LAN IP address is 192.168.1.1.
To Next Page
Loading...
