DVR Server Manual
By default, the entire screen is set as motion detection area where is
indicated with green border around the image. To mask a specific area, you
can click button to cancel the full screen detection border; then
Left-Single-Click and drag a rectangle to mark the area. A green rectangle will
mark the area of it. Also, you can set any other areas. Any activities in the
motion detection areas will trigger recording, depending on the reaction mode;
and alarms may be generated along with electronic map icons flashing in alert
mode. Click button to test the sensitivity of motion detection. The
sensitivity can be adjusted by dragging the slider bars below the motion
detection window.
The Sensitivity value bar is used to adjust the sensitivity of the area you
selected. The sensitivity value is smaller the motion detection is more
sensitive.
The motion value bar is used to set the minimum acreage of full screen to
trigger alarm. Its unit is percent, if the acreage of motion area exceeds the
setting value of the areas you selected, system will trigger alarm. The default
value of Sensitivity and Motion is 2 and 5%.
45
To Next Page
Loading...