4.12 Auto-sequence
FRA5087
c) Miscellaneous
Recording/storage and execution of a sequence cannot be done from the GPIB.
The auto-sequence mode turns to be [NON-ACTIVE] through execution of initialization
[INITIALIZE]; however, the content of recorded sequence is maintained.
When you record any of the ITEM keys
in the key
sequence, it sometimes occurs that the desired item is not properly selected
depending on the key display status or on the currently selected item. If this
occurs, select the desired item by using the item keys ITEM
, after the desired item is moved to the top by the function key [CURSOR
TO TOP].
4.13 Simplified load/save of setting conditions
You can easily load/save the FRA5087 setting conditions from/to the USB flash drive without
entering a file name. Storing the frequently used conditions in the USB flash drive lets you easily
read and use such conditions.
4.13.1 Simplified condition load
If a condition file having the name “CURRENT.CON” is present in the USB flash drive when
you press the CONDITION LOAD key, then an information message for confirming whether to
continue the load appears. To execute loading, press [CONTINUE] in the function display section
in lower part of the LCD. By doing so, the setting conditions in “CURRENT.CON” are loaded.
To Next Page
Loading...
